Separable Connector

24kV Separable Tee Connector front plug (bolted type) for connecting polymer-insulated cables to equipment (e.g. transformers, switchgear, distribution cabinets, generator sets...)

The European rear-type surge arrester provides reliable overvoltage protection for electrical systems.
With exceptional resistance to UV radiation, ageing, water, and moisture, the arrester delivers safe and dependable performance even under harsh environmental conditions.

The busbar, in combination with 630A cross joints and tee joints, provides a fully sealed and fully insulated connection to the load break switch.
This design completely eliminates the fatal defects caused by exposed high-voltage conductors under harsh environmental conditions.
Ring Main Units (RMUs) assembled with busbar systems using cross joints and tee joints offer lower cost and higher reliability.

12kV Separable Tee Connector front plug (bolted type) for connecting polymer-insulated cables to equipment (e.g. transformers, switchgear, distribution cabinets, generator sets...)

The European rear-type surge arrester provides reliable overvoltage protection for electrical systems.
With exceptional resistance to UV radiation, ageing, water, and moisture, the arrester delivers safe and dependable performance even under harsh environmental conditions.

The 12kV 630A Insulation Cap is an accessory for energized bushings, providing an insulating enclosure for live bushings and a dust- and moisture-proof cover for de-energized interfaces. It can be installed on 630A bushings, busbars, and wall-mounted equipment. When spare outlets are reserved on busbars or cable terminations, the 630A insulation cap must be used to seal them.

The busbar, in combination with 630A cross joints and tee joints, provides a fully sealed and fully insulated connection to the load break switch.
This design completely eliminates the fatal defects caused by exposed high-voltage conductors under harsh environmental conditions.
Ring Main Units (RMUs) assembled with busbar systems using cross joints and tee joints offer lower cost and higher reliability.